Page 11 of 14
Posted: Mon Sep 22, 2014 10:22 pm
by A280Z
Pedey wrote:Looking sweet! Not going RB any more I see?
rb is still sitting patiently waiting. This was meant to just be a paint the bay job then throw the L back in but seems to have escalated some how...
Posted: Tue Oct 07, 2014 8:03 am
by A280Z
Bit more progress
Last few bits back from electroplaters so could finally put the carbs back together and bolt them back on.
Radiator mounted for the last time hopefully and water hard lines done.
Because of my new home made strut brace I had an issue with my old fuel line setup not clearing. So had to get all crazy with AN fittings to make it work, yep its totally ridiculous but only way I could make it clear brace and throttle linkage gear.
Shes pretty tight, but all sort of fits
Catch tank mounted and plumbed
Coil up front
As it sits now, pretty much all the mechanical stuff now done thankfully
Wiring nightmare now begins...
Posted: Tue Oct 07, 2014 10:10 am
by mike260z
Wow that is just amazing , excellent work as always man
Posted: Tue Oct 07, 2014 10:54 am
by Karljsw
Oooo shiny
Looking good!!
Posted: Tue Oct 07, 2014 11:23 am
by nzeder
Looks very bling great job.
I see Motorsport regs now state the breather bottle/catch can now must be located on the opposite side to the exhaust. Not sure if Land Transport have the same requirements might pay to check.
Posted: Tue Oct 07, 2014 11:42 am
by Andy
nzeder wrote:Looks very bling great job.
I see Motorsport regs now state the breather bottle/catch can now must be located on the opposite side to the exhaust. Not sure if Land Transport have the same requirements might pay to check.
Bugga, reminds me of the Blackadder episode when Edmund came up with some missing words!
https://www.youtube.com/watch?v=hOSYiT2iG08
Engine compartment looks good, nice with the coil and plug wires tucked away. Hope that beautiful engine has a C type box behind it.
Posted: Tue Oct 07, 2014 2:37 pm
by A280Z
nzeder wrote:Looks very bling great job.
I see Motorsport regs now state the breather bottle/catch can now must be located on the opposite side to the exhaust. Not sure if Land Transport have the same requirements might pay to check.
I had it in a similar spot for the last warrant and wasn't an issue but cheers for the heads up.
Posted: Tue Oct 07, 2014 5:04 pm
by waidez
Oh sooooo sexy! Very nice work.
Posted: Tue Oct 07, 2014 6:45 pm
by merlin
Very nice work. I can really appreciate the time and effort to do a nice job not to mention the money.
Posted: Mon Oct 13, 2014 10:31 am
by A280Z
Started making some headway on the wiring. The original loom was in a pretty messy state due to years of people cutting and splicing not to mention my car having had a LHD to RHD conversion along the way. I have cut away as much of the old redundant fuel injection wiring as possible.
Front end done. Replaced a few of the old connectors and tried to route as neat as I can. All wiring now runs through the guard as wanted to try and keep the engine bay clean.
Engine bits finished. New 2G cable running to battery in the back of the car
Through firewall
I managed to score some sweet sealed 12V battery's from Craig260 to replace my old dead one, chur bo! These things are nice and small which is cool. One should do the trick but am going to use two.
Knocked up these guys to mount them
Decided to mount behind the rear seats, they just squeeze in there.
Posted: Mon Oct 13, 2014 11:21 am
by limezed
nzeder wrote:Looks very bling great job.
I see Motorsport regs now state the breather bottle/catch can now must be located on the opposite side to the exhaust. Not sure if Land Transport have the same requirements might pay to check.
That's a great rule. So what do you do with a V configured engine?
Posted: Mon Oct 13, 2014 11:49 am
by A280Z
limezed wrote:nzeder wrote:Looks very bling great job.
I see Motorsport regs now state the breather bottle/catch can now must be located on the opposite side to the exhaust. Not sure if Land Transport have the same requirements might pay to check.
That's a great rule. So what do you do with a V configured engine?
Bolt it to the bumper?
Posted: Sat Nov 01, 2014 9:40 pm
by A280Z
Posted: Sun Nov 02, 2014 12:21 am
by Moddy
Jesus this thing is beautiful. You really cant put that RB in her anymore haha, you've GOT to keep the L-series
Posted: Thu Nov 13, 2014 4:29 pm
by HasMilk
This thing looks simply amazing, and bad ass with the hood off.. Makes ya' wanna throw her around some corners, gracefully