Good Luck to the Targa crews

General natter about Datsun/Nissans
Post Reply
User avatar
old_datto_fan
Z Club Member
Posts: 951
Location: Kapiti

Good Luck to the Targa crews

Post by old_datto_fan » Wed Oct 12, 2016 4:37 pm

Good luck to all involved in Targa starting tomorrow. Wish we were out there with you.
Will be watching around Wanganui on Friday and will be at Cop Corner so make sure you put on a show for us Andy!

User avatar
old_datto_fan
Z Club Member
Posts: 951
Location: Kapiti

Post by old_datto_fan » Thu Oct 13, 2016 10:03 pm

Anyone know what happened to Andy today - looks like he has maximum times for all except the first stage?

User avatar
bernjean
Z Club Member
Posts: 1712

Post by bernjean » Fri Oct 14, 2016 8:13 am

Total awesome. He has been working hard. Well done Andy.
Bernie Kant
Club President

BRONZEE
Z Club Member
Posts: 7200
Location: Auckland

Post by BRONZEE » Fri Oct 14, 2016 9:02 am

GOOOOOOOOOOO ZEDS!
Next - Z Club events:
= Check out events page here or our Z Club NZ Facebook page.

User avatar
Andy
Site Admin
Posts: 2020
Location: Auckland

Post by Andy » Fri Oct 14, 2016 5:19 pm

Car broken, big bang half way through stage two at around 160kph as the oil pump drive decided to jump a cog or two, this shaft doubles as the cam sync so nobody home. Long story, short unsure of engine damage, could have repaired the cogs on the crank and the drive, but probably further damage on a very old engine (now over 20,000km's) and once you loose 3 stages you might as well go home if you're interested in results. This is the first DNF for us in a multi day Targa event. Car is home and is hanging its head in a corner. No decent times to show I would say stage 1 would be discounted as a timed stage as there a some serious anomalies.

Thanks for the support from club members.

BRONZEE
Z Club Member
Posts: 7200
Location: Auckland

Post by BRONZEE » Sun Oct 16, 2016 4:36 pm

There's always another event. 8)
Next - Z Club events:
= Check out events page here or our Z Club NZ Facebook page.

Post Reply