Triple carb sizing question

If your post does not fit under any of the other technical forums post it here
Post Reply
User avatar
Pedey
Posts: 257
Location: Auckland
Contact:
Contact Pedey

Post by Pedey » Fri May 24, 2013 8:58 am

Thanks for the feedback, good to know it will all work out. I have another page, which I believe has the clearances on it.
Top
User avatar
nzeder
Site Admin
Posts: 1503
Location: Auckland
Contact:
Contact nzeder

Post by nzeder » Fri May 24, 2013 10:23 am

That should be good - cam is only part of the equation mind you ;)
Top
Post Reply

Return to “General Technical”