Restores, Revamps and Repairs
6 posts • Page 1 of 1
The issue to also consider is the best adhesive to use when installing them. A lot of aftermarket rubber seals have a high silicon content and does not seem to bond with the adhesives recommended. I have tried several on my door seals and the all come unstuck.
I have a full set of seals supplied from MSA (thezstore.com) and they're fantastic. I dont know about any of the others but the door seals dont even need adhesive. They've been on the car for at least a couple years now and ive never had to touch them. I believe they're from a 200sx or possibly early rx7 so they're a modern single piece seal instead of the terrible old 2 piece seals the Z came with. The trunk seal is a little bit on the shit side though. Ive had to glue it back on at least twice since i replaced them and they're currently in need of it again as mentioned by another in this thread, i just cant seem to find a glue that will hold them down permanently. Maybe i need to be more ruthless with my glue selection.
***** Drive it like you stole it *****