yes
ricky@cooperz.co.nz

I have a diesel crank which I am looking for $300 Sold 1 x L28 crank $30 2 x 260Z large tube front struts with gland nuts $100 each. 1 x 240Z drive shaft and diff flange was reconditioned with better UJ's kept as a spare $100 2 x new outer rear wheel bearings RLS10 C4 $100 each Sold 2 x old camshaft...

Borrow my crank bearing cap puller tool, it makes an easy job of it.

Cheers Ricky

Throw the washer away, Nissan stopped fitting them as they flattened out allowing the nut to loosen.

I don't have any trouble with my R200 and CV half shafts but breaking the weld on the stub axle is a problem.

https://www.youtube.com/watch?v=iDj0x9MLRX4

Cheers
Ricky

I think you may have underestimated the size of the pump you need, the one you have installed is rated at 20 gallons per hour. The one you have removed looks like the Carter 70 gallon per hour pump which although noisy is spec’ed right for an L28 with side drafts and a cam. The problem is timing whe...

Hi, Due to the cancellation of a race meeting there is a private track day tomorrow (Easter Sunday) at Hampton Downs. The cost to do the track day is $125, there will 15 minute sessions overalls and helmets required. There will also be family sessions where you can take the family around in the fami...

Hi Peter Nissan never used them on there L series 6 cylinder engines, Nissan motorsport never used them in racing, BRE never used them and I haven't used them. They are required on 4 cylinder engines as then tend to suffer major vibration issues when pulling big rev's. They wont hurt your engine you...

Hi there,
I have a 260Z companion flange in my spares, I also have some flange nuts and bolts.

PM me with an offer.

Ricky

I almost brought that car 11 years ago off a guy in Blenheim, it looked stunning on Trademe but when I got there to drive it home I discovered how rusty it was. I bailed on the sale and got bad feedback even though the owner agreed and accepted that the car was in poor shape.

Ricky

Gear Cutting Services, talk to Roger Gordon

www.gearcutting.co.nz
5705363

They have a local office, details below http://www.rustoleum.ca/cbgcorporate.asp?sn=in&ci=28 MMP (NZ) Ltd. 5/33 Elizabeth Knox Place Mt. Wellington Auckland New Zealand Postal Address: P.O. Box 18-243 Glenn Innes Auckland New Zealand (64) 9-570-1461 Phone (64) 9-570-1462 Fax Mr David King Managi...

These Guys used to stock them

Swift Automotive Ltd 31 Carmen Rd Hornby Christchurch 8042 20076

I have four ugly mag’s and some used race tyres which would be perfect for this event for sale if anyone is keen. The rims are 16 x 7 perfectly round with no damage and will fit any 240, 260 or 280ZX and clear any brake or spring setup. The tyres are one pair of Toyo R888 225 x 45 x 16 and a pair of...